How do vaporing Coolers Work?
Evaporative coolers, also known as swamp coolers, are ordinarily used in hot, dry climates. According to the department of Energy, they use about one quarter of the power as a typical air conditioner. Swamp coolers work well in a non-humid environment because of how they work to cool the air. Water is pumped from a depot in the bottom of the unit. It is then ran straight through a fiber matting filter. Face air is cooled by an air compressor which blows it straight through the wet filter directly into the house. The air being blown straight through the wet filter lowers the inside temperature.
Compressor Troubleshooting
Troubleshooting Tips for Swamp Coolers
As with any equipment, sometimes it becomes essential to make repairs. Sometimes you can perform cooler mend yourself. This is regularly when the mend requires a minor fix. However, for larger repairs or if problems still exist, it is essential for you to call in an expert. There are a few troubleshooting tips that a homeowner can perform if they feel comfortable. A few items that the homeowner may need on hand before conducting any troubleshooting performance on their swamp cooler are a float bulb, a float operate valve, a circulation pump, household bleach, a scrub brush, a fan belt, new wet cells, and a new secondary filter.
These tips are as follows:
- Remove the wet cells from the swamp cooler and recognize them for damage or signs of mold and algae growth.
- Check the float operate valve. This valve regulates the level of the water reservoir. Push the bulb float into the tank to open the valve.
- Water should fill the water tank, if it does not, then you need to replace the float valve assembly.Turn the circulation pump on to recognize the flow of water straight through the upper tray. If the pump fails to operate, you may have to replace it.
- Check the tension of the fan motor belt to the circulation fan. If the belt is worn, you need to replace it.
- Pour approximately one cup of bleach into the depot tank and turn on the circulation pump. The bleach should flow straight through your entire system. This will clean and deodorized it to help preclude increase of algae and mold.
- Drain the swamp cooler and scrub the swamp cooler parts with a brush. Then run clean water straight through your system.
- Refill the swamp cooler with fresh water using the float operate valve.
- Replace the wet cells with new ones.
- Replace the interior air filter with a new one.
- Double check all things you have done.